Ciscomotors C-Max Manuel d'utilisateur télécharger pdf (Page 6)

Page 6

1.3 RUNNING-IN PROCEDURE

Following proper break-in procedure helps censure that some of the most important and

expensive components on your new C-Max will provide maximum performance and service

life. (Also follow proper run-in procedure for a newly rebuilt engine)

1. Do not hold the throttle in one position for more than a few seconds. It’s better

to roll the throttle on and off, without getting too high altitudes and forcing the

engine.

2. Use the motor for features of 10 minutes at a time and to leave to cool it.

3. After 5 hours of use or approximately 20 litres of gasoline the motor should be

broken in.

4. This same procedure should be followed each time

• Piston is replaced

• Cylinder is replaced

• Crankshaft or crank bearings are replaced

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Pas de commentaire

Ciscomotors C-Max Manuel d'utilisateur Page 6